1

Metallurgical Quality Performance Requirements Of Bearing Steel

2023-12-01

Higher dimensional accuracy requirements, for hot-rolled annealed bars forged on high-speed upsetting machines, there should be higher requirements for dimensional accuracy;

The Working Principle Of Bearing Heater And Its Eight Characteristics

2023-12-01

The bearing heater is composed of a dry self-cooling power frequency induction heating device, referred to as the host and control equipment.

What Is The Bearing Static Load Rating And Dynamic Load Rating?

2023-12-01

The three basic parameters that are often used in the design of rolling bearings are: the basic rated dynamic load Cr (radial) or Ca (axial) that meets certain fatigue life requirements; the basic rated static strength Cor (diameter) that meets certain static strength requirements direction) or Coa (axial) and limiting speed No to control bearing wear.

How To Balance The Axial Thrust Of A Water Pump？

2023-12-01

Drill a few holes on the back cover of the pump near the hub, and add a sealing ring on the back cover. The outer diameter of the sealing ring is equal to the outer diameter of the impeller suction inlet.

The key method of maintaining low noise embedded solid lubricating bearing

2023-12-01

When the mechanism is running, the part of the embedded solid lubricating bearing is allowed to have a certain temperature. When touching the shell of the mechanism by hand, it should not feel hot, otherwise it indicates that the bearing temperature is too high.

Design skills of friction in machining accuracy of bearings

2023-12-01

The superfinishing sequence of bearings can be generally divided into three steps: cutting, half cutting, finishing.